The program will provide participants skills and knowledge on complicated mould design which required sliders and lifters. In addition, it will also provide participants the ability to trouble shoot injection parts and mould defects

OBJECTIVE

After successful completing this program, the participant will be able to:
• Create sliders and lifters.
• Trouble shoots injections parts and mould defects.

TARGET GROUP

Draughtsman, Product Designer, Mould Designer, Product Development Executives or Engineers and those are in the designing field.

COURSE OUTLINE

Unit 1 Creating sliders

• Basic methods

i) Angular pin
ii) Wear plate design
iii) Stopper
iv) Spring stopper
v) Calculation of slider movement

Unit 2 Creating sliders

• Advance methods

i) Angular block
ii) Hydraulic
iii) Internal slider
iv) Ball bearing stopper
v) Clamp stopper

Unit 3 Creating lifters

• Basic methods

i) Calculation of lifter movement
ii) Maximum slant degree of lifter
iii) Basic lifter shoe design
iv) Wear plate design

Unit 4 Creating lifters

• Advance methods

i) Other lifter shoe design

• Creating guided ejection system

Unit 5 Trouble shooting

• Case study
• Exercise